TANDBERG Media Processing System MPS 200 - Manual (Page 34)

D 13373.08
NOVEMBER 2007 MPS
Table of
Contents
TANDBERG MPS
ADMINISTRATOR GUIDE
Initial Configuration (3:4)
Configuration of the MPS using Web Interface
Open a web browser and type in the IP address to
access the web interface. The IP address to enter
was configured from the LCD during the installation
process.
Simple PRI Configuration
Simple PRI Configuration
Navigate to System Configuration > PRI:
Set • Switch Type by selecting the apropriate PRI
protocol: National ISDN, AT&T Custom ISDN, ETSI
(Euro ISDN) or Japan/Taiwan ISDN.
All PRI lines on the same E1/T1 Interface Card
must use the same PRI Protocol.
If same number for all PRI’s set • Trunk Groups
to On.
Configure PRI Numbers in • Number Range Start
and Number Range Stop .
Please refer to section System Configuration
> PRI Board Configuration for details.
Save - Press the Save button to save changes.
Simple PRI Configuration

34
Introduction
Using
the MPS
System
Status
System
Configuration
Installation
Gateway
Configuration
MCU
Configuration
Technical
Descriptions
Appendices Main
Quick
Setup