Configuring lcs and mps for sip (4:6) – TANDBERG Media Processing System MPS 200 User Manual
Page 176
D 13373.08
NOVEMBER 2007
MPS
TANDBERG
MPS
ADMINISTRATOR GUIDE
MPS DNS Configuration
Configuring LCS and MPS for SIP (4:6)
DNS Configuration
To configure the DNS server on the MPS, navigate to System Configura-
tion > IP:
Locate the configuration for the particular Service Controller Interface
the system will use and enter the
IP Address
of the Domain Name
Server (DNS) Interface 1. Up to five DNS addresses can be configured.
SIP is only supported on DNS Interface 1.
Please refer to section
System Configuration > IP Configuration
for
more details.
Configuring the MPS
The Microsoft Live Communication Server (LCS) should be config-
ured prior to the MPS unit.
The MPS configuration consists of ensuring the MPS has a valid DNS
name server configured and entering the LCS server information.
DNS Server Configuration
The LCS SIP operation requires the MPS to have a valid DNS (Domain
Name System) server configured.
If the DNS server is not configured properly, calls may connect to
the MPS, but neither video nor audio will be transmitted to the far
end.
!
MS Live Communications Server
176
Introduction
Quick
Setup
Using
the MPS
System
Status
System
Configuration
Installation
Gateway
Configuration
MCU
Configuration
Technical
Descriptions
Main
Appendices