Video settings (3:5) – TANDBERG Media Processing System MPS 200 User Manual
Page 135
D 13373.08
NOVEMBER 2007
MPS
TANDBERG
MPS
ADMINISTRATOR GUIDE
Conference Template
Conference Template Configuration
The Conference Templates are found in the MCU Configuration tab.
The predefined settings will be used as default settings when creating
new conferences based on this specific template. TANDBERG MPS
enables the setup of 10 different conference templates.
The conference template contains the same settings as de-
scribed in the
in the Overview section.
Conference Template Configuration
Video Settings (3:5)
Dual Video Stream
The MCU supports DuoVideo
TF
, H.239 and BFCP.
On:
Set to On to enable Dual Video Stream for this conference. Both
DuoVideo
TF
, H.239 are supported in the same conference.
Off:
When set to Off, Dual Video Stream will not be supported in this
conference.
Conference Selfview
On:
Set to On to enable Conference Selfview. The user will see
himself in the picture when more than one participant is in the confer-
ence.
Off:
Set to Off to disable Conference Selfview.
Telephone Indication
On:
Set to On to enable a Telephone Indicator to be displayed when
there are telephone (audio only) participants connected to the confer-
ence. When the telephone participant is speaking the indicator will be
outlined.
Off:
Set to Off to disable the Telephone Indicator to be displayed.
Speaker Indication
On:
Set to On to enable a Speaker Indicator (a coloured line) to be
displayed around the sub-picture that will indicate who is the currently
speaking participant.
Off:
Set to Off to disable the coloured line to be displayed.
Lecture Mode
On:
Set to On to enable the Lecturer to be displayed in full
screen to the other participants.
The Lecturer is the participant which is assigned floor.
•
The Lecturer will see a scan of all the participants in a full
•
screen view or one of the supported sub-picture views.
Off:
Set to Off to disable the Lecturer, the participant which is
assigned floor, to be view in full screen.
Press
Save
to activate the new settings
135
Introduction
Quick
Setup
Using
the MPS
System
Status
System
Configuration
Installation
Gateway
Configuration
Technical
Descriptions
Appendices
Main
MCU
Configuration