TANDBERG Media Processing System MPS 200 - Manual (Page 89)

D 13373.08
NOVEMBER 2007 MPS
Table of
Contents
TANDBERG MPS
ADMINISTRATOR GUIDE
PRI Board
Network Configuration
NSF Telephony Number
Your network provider may require a service selection in your
ISDN configuration.
Enter the Service code here. Valid NSF service codes are
from
0 to 31 (National, AT&T or Japan/Taiwan ISDN).
NSF Telephony Mode
On:
If set to on, NSF service code for telephone calls will be
enabled.
Off: If set to off, NSF service code will be disabled (Default:
Off).
Speech Timers
On:
If set to on, this will turn on Layer 3 timers T310, T304
and T301 for telephone calls (Default: On).
Off: If set to off, this will turn off Layer 3 timing.
PRI Board in Slot 1-n (2:3)
NSF Video Number
Your network provider may require a service selection in your
ISDN configuration.
Enter the Service code here. Valid NSF service codes are
from
0 to 31 (National, AT&T or Japan/Taiwan ISDN).
NSF Video Mode
On:
If set to on, NSF service code for video calls will be
enabled.
Off: If set to off, NSF service code will be disabled (Default:
Off).
PRI Board Configuration
Please ensure that Network Type is set to PRI for the
correct ISDN cards in the PRI Network Configuration .
!
Save - Press the Save button to save changes.
NSF - Network Specific Facilities
Read about
NSF Service Codes in Technical Descriptions.
89
Introduction
Quick
Setup
Using
the MPS
System
Status
Installation
Gateway
Configuration
MCU
Configuration
Technical
Descriptions
Appendices Main
System
Configuration