TANDBERG Media Processing System MPS 200 - Manual (Page 56)

D 13373.08
NOVEMBER 2007 MPS
Table of
Contents
TANDBERG MPS
ADMINISTRATOR GUIDE
MCU Overview > Manage an Active Conference
Add Participants (2:3) - Manual Dialing (1:2)
Conference Status
The Conference Status page shows information about a con-
ference and lets you control the conference.
Number
Enter the video number, telephone number or RS366 dial
string.
For G.703 Leased Line calls, this is the call number (1 to 5).
Add Participants
To add new participants to the conference, press the Add
Participants button . The Call Participants window will be
Call Type
Select the call rate to be used.
Use Default (default) is the configured Maximum Conferense
Rate.
Custom Selection : Use Default, 1 x H.221, 2 x H.221, 64
kbps, 128 kbps, 192 kbps, 256 kbps, 320 kbps, 384kbps,
H0, 512 kbps, 768 kbps, 1152 kbps, 1472 kbps, 1536 kbps,
1920 kbps and Telephone
Example : When calling an endpoint on a V.35 port configured
for 384 kbps and the default call rate is 768 kbps, you must
select 384 kbps to ensure proper framing and syncing.
Second Number
If two numbers are required, both should be specified for
2x64 kbps and 2x56 kbps calls.
Leave blank (default) if the endpoint only has one number.
Restrict (56K)
Select Restrict (56K) to use 56 kbps per ISDN B-channel.
56
Introduction
Quick
Setup
System
Status
System
Configuration
Installation
Gateway
Configuration
MCU
Configuration
Technical
Descriptions
Appendices Main
Using
the MPS