TANDBERG Media Processing System MPS 200 - Manual (Page 105)

D 13373.08
NOVEMBER 2007 MPS
Table of
Contents
TANDBERG MPS
ADMINISTRATOR GUIDE
Miscellaneous Configuration
Miscellaneous Configuration
Configuration - System name
To change the System Name of the TANDBERG MPS, enter
the new system name in the field.
System Clock
Port:
Enter the port number for the System Clock.
Defines which ISDN or V.35 port the system will receive
network clocking from. This will only be pulled from the slot 1
network card.
Services
The IP services can be independently disabled to prevent ac-
cess to the TANDBERG MPS.
Miscellaneous Configuration
Save - Press the Save button to save changes.
Restart - For the settings to take effect the unit must be restarted after pressing the Save button.
Change Password
To change the password of the system, you need to
log into the Command Line Interface. For information
please see the TANDBERG MPS API document sup-
plied with the system or on
http://www.tandberg.com
HTTP
On:
Set HTTP to On to enable HTTP Service.
Off: Set HTTP to Off to disable HTTP Service.
HTTPS
On:
Set HTTPS to On to enable HTTPS Service.
Off: Set HTTPS to Off to disable HTTPS Service.
Telnet
On:
Set Telnet to On to enable Telnet Service.
Off: Set Telnet to Off to disable Telnet Service.
SSH (Secure Shell)
On:
Set SSH to On to enable SSH Service.
Off: Set SSH to Off to disable SSH Service.
105
Introduction
Quick
Setup
Using
the MPS
System
Status
Installation
Gateway
Configuration
MCU
Configuration
Technical
Descriptions
Appendices Main
System
Configuration