TANDBERG Media Processing System MPS 200 - Manual (Page 33)

D 13373.08
NOVEMBER 2007 MPS
Table of
Contents
TANDBERG MPS
ADMINISTRATOR GUIDE
Initial Configuration (2:4)
Simple H.323 Configuration
Registration to a Gatekeeper
Navigate to System Configuration > H.323:
Set the • Gatekeeper mode to Gatekeeper to en-
able the system to register to a Gatekeeper.
Enter the • Gatekeeper IP Address .
When registered, the H.323 Gatekeeper
Status shows Registered, displays the Gate-
keeper’s IP address and the port used.
Problems with registration will be shown as
Registering and a Red alarm on the Confer-
ence Overview page.
Please refer to section System Configuration
> H.323 Configuration for details.
Save - Press the Save button to save changes.
Simple H.323 Configuration

Configuration of the MPS using Web Interface
Open a web browser and type in the IP address to
access the web interface. The IP address to enter
was configured from the LCD during the installation
process.
33
Introduction
Using
the MPS
System
Status
System
Configuration
Installation
Gateway
Configuration
MCU
Configuration
Technical
Descriptions
Appendices Main
Quick
Setup