TANDBERG Media Processing System MPS 200 - Manual (Page 57)

D 13373.08
NOVEMBER 2007 MPS
Table of
Contents
TANDBERG MPS
ADMINISTRATOR GUIDE
MCU Overview > Manage an Active Conference
Conference Status
The Conference Status page shows information about a con-
ference and lets you control the conference.
DTMF String
Specify the DTMF (Dual Tone Multi-Frequency) or Touch Tone
string.
Network Module
Specify which Network Interface Card to use for outgoing
calls. Enter a value between 0 and 6.
Optional for ISDN calls •
Mandatory for V.35 calls and G.703 Leased Line calls. •
Network ID
Used to identify port or interface number within a network
module. Enter a value between 1 and 32:
Specify which IP network to use, only • 1 and 2 are valid
values (optional).
Specify which V.35 port to use (mandatory). •
Add Participants (3:3) - Manual Dialing (2:2)
Subaddress
The Subaddress is used to address different participants on
the same ISDN line or TCS4 dialling.
Dial Profile
Select which dial profile to use for this phone book entry.
Auto: The MPS will automatically select the appropriate profile
ISDN: ISDN will always be used for dialling.
H.323: IP will always be used when dialling.
SIP: SIP will always be used when dialling.
If defined, custom Dial Profiles (Network Profiles) will show in
the list. See
MCU Configuration for more information.
57
Introduction
Quick
Setup
System
Status
System
Configuration
Installation
Gateway
Configuration
MCU
Configuration
Technical
Descriptions
Appendices Main
Using
the MPS