TANDBERG Media Processing System MPS 200 - Manual (Page 104)

D 13373.08
NOVEMBER 2007 MPS
Table of
Contents
TANDBERG MPS
ADMINISTRATOR GUIDE
QoS Configuration
QoS (Quality of Service) Configuration
QoS Configuration (network 1-2)
The network must support Quality of Service (QoS) for these
settings to work. You can configure the Quality of Service
mode differently for Network #1 and Network #2.
Network Configuration
QoS Mode (network 1-2)
Precedence:
Select IP Precedence QoS method and see
QoS Mode Configuration for details.
Diffserv: Select Diffserv QoS method and see QoS Mode
Configuration for details.
Off: No QoS is used.
Save - Press the Save button to save changes. QoS Type of Service Priority
Minimum Delay:
Will choose a route where minimum delay is
prioritized.
Maximum Throughput: Will choose the route with highest
bandwidth is prioritized.
Maximum Reliability: Will choose the route where minimum
packet loss is prioritized.
Minimum Cost: Will choose the cheapest connection avail-
able.
Off: Quality of Service not active.
QoS Mode Configuration
Diffserv • is used to define which priority audio, video,
data and signalling packets should have in an IP network.
The priority ranges from 0 to 63 for each type of packets.
Precedence • is used to define which priority audio, video,
data and signalling should have in an IP network. The
higher the number, the higher the priority. The priority
ranges from 0 (Off) to 7 for each type of packets.
In addition to Precedence, • Type of Service can be used
and enables the user to define what type of connec-
tion that should be chosen for the IP traffic. This helps
a router select a routing path when multiple paths are
available.
104
Introduction
Quick
Setup
Using
the MPS
System
Status
Installation
Gateway
Configuration
MCU
Configuration
Technical
Descriptions
Appendices Main
System
Configuration