TANDBERG Media Processing System MPS 200 - Manual (Page 45)

D 13373.08
NOVEMBER 2007 MPS
Table of
Contents
TANDBERG MPS
ADMINISTRATOR GUIDE
MCU Overview > Create Conference
Participant Identifier
Auto:
Set to Auto to let the System Name of a participant to
be displayed the number of seconds set in Participant Identi-
fier Timeout.
On: Set to On to enable the System Name for each participant
to be displayed in the picture during the conference.
Off: Set to Off to disable the System Name to be displayed.
Participant Identifier Timeout
Set the number of seconds (1 - 30 seconds) the Participant
Identifier will be visible, if set to auto. The identifier will re-
appear at every picture changing event.
Chair Control
On:
Set to On to enable Chair Control. The conference sup-
ports H.243 and BFCP Chair Control functionality initiated
from the participants connected to the conference.
Off: Set to Off to disable Chair Control,
Minimum Bandwidth Treshold
If a participant calls in with a lower bandwidth than the Mini-
mum Bandwidth Threshold, the participant will receive audio
only (not live video) as well as a poster saying the bandwidth
is to too low. After 10 seconds the participant will receive low
rate video.
The Minimum Bandwidth Threshold can be modified during •
a conference.
The system will move calls below the defined Minimum
•
Bandwidth Threshold to a low rate encoder.
NOTE: Once a participant is moved to the low rate encoder,
they will not be moved back even if the Minimum Bandwidth
Threshold is lowered.
Create Only
Select Create Only to create a confer-
ence, with the above-specified configura-
tion, without dialling out to any partici-
pants.
Add Participants
Select Add Participants to add participants
or to manually dial a participant.
Cancel
Select Cancel to discard all changes and
return to the Conference Overview page.
Video Settings (4:5)
45
Introduction
Quick
Setup
System
Status
System
Configuration
Installation
Gateway
Configuration
MCU
Configuration
Technical
Descriptions
Appendices Main
Using
the MPS