TANDBERG Media Processing System MPS 200 - Manual (Page 64)

D 13373.08
NOVEMBER 2007 MPS
Table of
Contents
TANDBERG MPS
ADMINISTRATOR GUIDE
MCU Overview > Manage an Active Conference
The Advanced View
Conference Status
The Conference Status page shows information about a conference and
lets you control the conference.
Basic View - Provides a basic overview of all the participants in the
conference.
Advanced View - Gives detailed information on the audio in, audio out
and video in protocols and the bandwidth used by these protocols.
Terminal List - List the participants in the conference. If the conference
is cascaded to another conference, this will be shown here.
Change - The change view is used to modify endpoint constraints or
move the endpoint to another conference.
The Advanced View
The Advanced view gives a more detailed picture of the conference than
the Basic view.
Audio In/Out: Shows the audio protocol in use, and bandwidth used by
the protocol.
Video In: Shows the video protocol in use, and bandwidth used by the
protocol.
Click on a participant name
to show the Call Info page.
Paticipant Info Page
To see all details about the call for each participant, click in the partici-
pant name and Participant information page is shown.
Call Info
Contains information about Call Status, Call, In/Out/Q.931 Rate, Num-
ber, Dial In Number, TerminalID, TerminalName, Duration and Encryption.
Media Info
Contains information about Audio with Dynamic Rate, Packet Loss,
Packet Drop, Jitter, RSVP, Local Address and Remote Address; and Video
with Dynamic Rate, Packet Loss, Packet Drop, Jitter, RSVP, Local Address
and Remote Address; and Dual Stream, Data and Cap Set.
Refresh: Press the Refresh button to do a quick refresh of the page.
Previous/Next: Press the Previous or Next button to see the previous or
next participant page.
Need a snapshot
64
Introduction
Quick
Setup
System
Status
System
Configuration
Installation
Gateway
Configuration
MCU
Configuration
Technical
Descriptions
Appendices Main
Using
the MPS