Ricoh 2400L - Manual (Page 83)

Switching Memory Lock On/Off
Before you can use Memory Lock, you have to switch it on using Function 62.
After you switch Memory Lock on, (MEMORY LOCK) will appear on the display
when the machine is in standby mode.
NOTE: If you switch Memory Lock on, Forwarding will be automatically disabled.
1. Function 6 2 2 2 2 6 2 and Yes. Y/NEXTk
SELECT LINE
2. Scroll through the features with
k
until the
screen is as shown opposite.
Y/NEXTk
MEMORY LOCK ON/OFF
3. Yes. MEMORY LOCK Y/j k
ON kOFF
4. Change the on/off setting by pressing
j
or
k
.
MEMORY LOCK Y/j k
kON OFF
5. Finsh
:
Yes and Function.
If you wish, you can prevent unidentified senders from sending you messages while Memory
Lock is on. See page 76.
Programming Special Terminals for Memory Lock
If you would like to receive information from only select locations into Memory
Lock, you can program the RTI codes or CSI codes of those locations. A terminal
sending an incoming message always identifies itself to your terminal. The
identification consists of an RTI or a CSI. When you specify the senders for
Memory Lock, you must program a list of these codes. Program the list using
Function 81 called "Special Terminal" (see page 94).
Selecting Which Messages to Lock in Memory
You have to select either to:
❐ Only Lock messages from Special Terminals.
❐ Lock all messages except those from Special Terminals.
1. Function 6 2 2 2 2 6 3 and Yes.
At this time, you can print a User Pa-
rameter List if you press
j
and Start.
SETTING? Y/j
PRINT LIST j
2. Yes. KPAD/Y/j k
SWITCH 00 :0000 0000
RECEPTION ADVANCED FEATURES
74