Ricoh 2400L - Manual (Page 160)

DISPLAYED ERROR MESSAGES
The following messages may appear while you are operating or programming the
machine.
CHECK AUTO-DIALING
You cannot use the auto-dialer at the moment. Use the ten
keypad or the handset.
NO FILE EXISTS
No polling reception operations have been programmed.
There are no messages in memory waiting for transmission.
There are no messages in memory waiting to be polled.
Incorrect file number. Check the file number and try again.
TOO MANY DEST.
The memory cannot hold any more telephone numbers.
Either: Delete some numbers then try again.
Or: Wait until some of the Send Later or other delayed
transmissions waiting in memory have been carried out, then
try again.
USED AS GROUP This Quick Dial key has a Group stored in it.
USED AS PROGRAM This Quick Dial key has a Keystroke Program stored in it.
USED AS DIAL
This Quick Dial key has a telephone number stored in it.
USED AS AUTO DOC. This Quick Dial key has an Auto Document stored in it.
USED AS TONE KEY
This Quick Dial key is programmed as the Tone key.
USED AS GROUP KEY This Quick Dial key is programmed as the Group key.
NOT PROGRAMMED
Either:
This Quick Dial key or Speed Dial Code does not contain a
number.
This Quick Dial key does not contain a Keystroke Program.
ALREADY PROGRAMMED
Either:
This number is already included in this Group.
This RTI/CSI has already been stored for use with this feature.
PLEASE SET PAUSE
You must add a pause after your area code when you input
your fax terminal’s own telephone number.
ADD TONER The toner cartridge is empty. Install a new cartridge.
CLEAR ORIGINAL
A document is jammed in the feeder.
CLEAR COPY Paper is jammed in the printer.
CLOSE COVER
A cover is not closed properly. Check that all covers are closed.
UNABLE USE PRINTER
The machine cannot print a list/file, because the heater is not
warm enough or the plotter is not ready.
SERVICE CALL J - JJ H
The machine is out of order. Contact your service
representative.
DISPLAYED ERROR MESSAGES SOLVING PROBLEMS
150