Ricoh 2400L - Manual (Page 218)

INTRODUCTION
Thank you for purchasing this product. This multi-function office machine offers a
wide range of fax, copier, printer, and convenience features.
What Does a Fax Machine Do?
When you write a letter, you normally seal it in an envelope, attach a stamp, and post it in the
nearest mail box. Then, in a few days, depending on the postal service, the letter will arrive at its
destination. However, you may not be aware of its arrival until you get a return letter.
A fax machine speeds up this process. After you have written your letter, place it in your fax
machine’s document feeder or on the exposure glass, dial the destination’s fax number, then press
the Start key.
The fax machine scans your letter, and converts it into a series of black and white dots (the
number of dots that there are across and down the page depends on the resolution that you
selected; refer to the specifications section of this manual for details). This series of dots is
transformed into an electrical signal and sent out over the telephone line to the destination fax
machine.
The receiving fax machine reconstructs your letter from the incoming signal, and prints it.
If you are worried about whether the message arrived at the destination, you can check a report
called the TCR (Transaction Confirmation Report). When you print this report, you will see the
results of the most recent fax communications made by your machine.
You can use your fax machine to send and receive many types of documents, even photographs.
Telephone Line Problems Affect Fax
Communication
Quick and accurate transmission of fax messages depends
on the condition of the telephone line. If the line condition is
very good, this machine will transmit a letter-size page in
about 9 seconds. However, if the line is noisy, the speed
may be reduced significantly, and the data may be
damaged.
The symptoms of data loss caused by a noisy telephone
line are seen on the printouts of received messages. An example is shown opposite. Note that
lines are missing from the page at the indicated locations. ECM (Error Correction Mode) is an
effective countermeasure against this type of error; you have the choice of having the ECM feature
switched on or off. It is switched on before the machine leaves the factory. (Refer to page 62 for
more information about ECM).
The line condition is affected by the weather; thunderstorms can cause electrical noise on
telephone lines.
In addition, the quality and condition of switching equipment used by your phone company can
affect fax communication.
INTRODUCTION
Errors
Received
Message
Document
Transmit
I
N
TRODUC
T
ION
1