Ricoh 2400L - Manual (Page 762)

Tonal Signals
On this model the ✽ key on the ten keypad is used as the Tone key. Some
organizations offer you a special service by telephone, which you can access by
transmitting Touch tone or DTMF tones. If your phone service provides only pulse
dialing, or if you are calling over a digital network, the ability to generate Tonal
Signals will allow you to access these services. First, dial the other party when
you are through to the other end, press the Tone key and enter the code number
that is needed to access the required feature at the other terminal. You do not
need to press the Tone key if your machine is set up for dialing in Tone Dial
(DTMF)mode.
Using the Tone Key
1
Make sure that the machine is in standby mode, and that there is no docu-
ment in the feeder.
2
Pick up the telephone handset.
3
Dial the remote facility. Do not press the Start key.
4
After your line is connected to the remote facility, do the following:
❐ If your telephone line type is DTMF (Tone Dial): Go to step 5.
❐ If your telephone line type is Pulse Dial: Press ✽ on the ten keypad. A dot
appears in the display.
5
Input the digits that you need to use the remote facility. After you have fin-
ished your business with the remote facility, hang up.
Note: Do not press the Start key.
A
D
V
A
N
C
E
D
F
E
A
T
U
R
E
S
ADVANCED FEATURES TRANSMISSION
71