Ricoh 2400L - Manual (Page 284)

Selecting the Halftone Type
This model has two types of Halftone: the Dither Process and the higher quality
Error Diffusion Process. To change the currently used Halftone type, perform the
following procedure.
1. Function 6 2 2 2 2 6 3 and Yes SETTING Y/j
PRINT LIST j
2. Yes.
The settings for switch 00 are now
shown on the bottom line of the display.
KPAD/Y/j k
SWITCH 00 : 0000 0000
3. Press
k
until the settings for switch 10 are
shown. You need to change digit 7.
If you wish change the setting press 7
on the ten key pad.
Digit 7
1: Speed mode
0: Standard mode
KPAD/Y/j k
SWITCH 10 :1000 0000
Speed mode: The machine will use the Basic Halftone Process.
Standard mode: The machine will use the higher quality Error Diffusion Process.
4. Finish: Yes and Function
Halftone Mode slows down the transmission speed, and may increase your
communication costs, especially if you use the Error Diffusion process. Higher
resolutions also do this. This is because these settings create larger amounts of
data to be sent.
Messages are transmitted the fastest if you use the standard resolution
setting, and keep Halftone off.
SENDING A FAX MESSAGE ROUTINE OPERATION
68