Ricoh 2400L - Manual (Page 171)

Switch 09 - Various
Digit Purpose
0, 1
Memory lock Digit 1 Digit 0 Setting
(Feature Expander Required) X 0 Off*
Locked messages are printed 0 1 Only Lock messages from senders
when you enter the memory whose RTI/CSI’s are programmed.
lock ID. 1 1 Lock all messages except those from
senders whose RTI/CSI’s are
programmed.
2 to 7 Do not change these settings.
Switch 10 Various
Digit Purpose
0 Reverse order printing (Feature Expander Required) 0: Off* 1: On
1 to 6 Do not change these settings.
7
Halftone mode 0: Standard Mode*
1: Speed Mode
Switch 11 Various
Digit Purpose
0 to 5 Do not change these settings.
6
Printing the received message when acting as a forwarding station.
0: Off 1: On*
7 Polling standby duration 0: Once* 1: Keep
Switch 12 Various
Digit Purpose
0 and 1 Do not change these settings.
2
Toner saving mode 0: Off* 1: On
Note:
If on, contrast will be set to "Normal" automatically, preserving image quality.
This is available when receiving fax messages and printing reports, but not for
copying or printing from a PC.
Further, messages sent to you in halftone mode will automatically turn off toner
saving to ensure a clear image.
To make sure that the fax quality is acceptable with toner saving on, print a few
reports (see page 117 ).
(Note: If the sender is using a machine made by another manufacturer, toner saving
will stay on and this could lower image quality.)
3 and 4
Density of the printing image
Digit 4 Digit 3 Setting Digit 4 Digit 3 Setting
0 0
Normal * 0 1 Lighten
1 0 Darken 1 1 Do not use
this setting.
5 to 7 Do not change these settings.
Switch 13 - Do not use.
TECHNICAL RE
FERE
NCE
TECHNICAL REFERENCE ON/OFF SWITCHES AND USER PARAMETERS
161