Raritan Computer DKX416 - Manual (Page 29)

Chapter 2: Installation
19
Configuring Network Firewall Settings
If you wish to access the Dominion KX through a network firewall, your
firewall must allow communication on TCP Port 5000. The Dominion KX
can also be configured to use a different TCP port of your designation
(see Network Configuration (on page 150) for additional information).
Optional: Take advantage of the Dominion KX's web-access capabilities.
To do this, the firewall must also allow inbound communication on TCP
Port 443 - the standard TCP port for HTTPS communication.
To take advantage of the Dominion KX's automatic redirection of HTTP
requests to HTTPS (for example, so users may type the more common
http:// instead of https://), the firewall must also allow inbound
communication on TCP Port 80 - the standard TCP port for HTTP
communication.
Note: Depending on hardware status, firewall ports may require
different settings. Refer to the table:
Port Old device New device
5000 UDP Can be used for
discovery Will be used for discovery
5002 UDP Can be used for
discovery Not supported
5000 TCP Can be used for
connecting to the
device Will be used for connecting
to the device
5001 TCP Can be used for
connecting to the
device Not supported