Raritan Computer DKX416 User Manual
Page 162
Network Configuration
152
Modem Initialization String: Used to configure modem
settings. Because different modems have different ways of
settings these values, this document does not specify how to set
these values, rather the user should refer to the modem to create
the appropriate modem-specific string.
Modem Settings:
Enable RTS/CTS flow control
Send data to the computer on receipt of RTS
CTS should be configured to only drop if required by flow
control.
DTR should be configured for Modem resets with DTR
toggle.
DSR should be configured as always on.
DCD should be configured as enabled after a carrier signal is
detected. (that is, DCD should only be enabled when modem
connection is established with the remote side)
If the modem string is left blank, the following string is sent
to the modem by default: ATS0=0Q0&D3&C1
Use default TCP port 5000: Besides the initial download of
Raritan Remote Client and KX Manager (which occurs over
secure HTTPS Port 443), all communication to and from the
Dominion KX occurs over a single, configurable TCP Port. The
default is Port 5000, but you can configure it to use any TCP port
except 80 and 443. To access the KX unit from beyond a firewall,
your firewall settings must enable two-way communication
through the default port 5000 or the non-default port.
Enable syslog forwarding: Click on this checkbox to the device's
log messages to a remote syslog server. Type the IP Address of
your syslog server in the Remote IP address field and click on
the Category and Priority threshold drop-down arrows to select
the level of event sensitivity.