NEC NEAX NDA-24349 User Manual

Page 64

Chapter 3 System Highlights

Page 3- 12

NEAX2000 IPS

Request For Proposal (RFP) Reference Guide

NDA-24349 Issue 4

PEG Count

The PEG counter is used for maintenance purposes to verify various data in the system. PEG counters
can be set by system programming to start and stop by month, day, hour and minute. A system reset
will clear all PEG count data. The following data can be measured by PEG count.

Trunk PEG Count

Number of outgoing trunk seizure by Trunk Route

Number of tandem connectioins established

Number of times a busy station was encountered

Number of all types of calls to Attendant Console

Number of connections giving Dial Tone

Number of station-to-station connections established

Number of failures caused by all senders being busy

Number of failures caused by all registers being busy

Number of failures caused by all ringing trunks being busy

Number of failures caused by all IP-PAD channels being

Number of incoming call seizure-Trunk Route

Number of times all trunks found to be busy trunk route

Number of incoming calls terminated to busy tone-Trunk Route

Number of unanswered incoming calls-Trunk Route

Number of register connection on trunk call-Trunk Route

Number of conference calls (Three/Four way Calling)

Number of failures cased by all conference trunks (For three way Calling) being busy

Number of transferred incoming calls to Attendant Console or predetermined station, by Call

Forwarding-Don’t Answer

UCD PEG Count

Number of answered calls on UCD station

Number of incoming calls to UCD Group

Number of call waiting calls for predetermined time in queuing mode on UCD Group

Number of abandoned calls to UCD Group

Number of incoming calls to all busy of UCD Group

Number of incoming calls to UCD Group that were answered

Number of times queuing

IP Network PEG Count

Number of times that traffic exceeded the limit bandwidth

Number of times that traffic exceeded the warning bandwidth

Maximum bandwidth used

Bandwidth used now