NEC NEAX NDA-24349 - Manual (Page 267)

Chapter 13 Voice Over IP (VoIP)
NEAX 2000 IPS Request for Proposal (RFP) Reference Guide Page 13- 9
NDA-24349, Issue 4
Service Conditions on Legacy Service Features
1. A DSS/BLF Console can be associated with the IP Enabled D term terminal, but the console must be
connected to a DLC card.
2. Multiple Line Operation with normal Multiline Terminal is available.
3. Service features requiring continuous voice transmission, such as the Background Music feature,
cannot be used because this traffic may reduce overall performance of the Local Area Network
(LAN).
4. CAT mode is available.
5. Soft Key and Help indication is supported.
6. Set Relocations is not available between IP Station and TDM Multiline terminal.
7. DTMF signal is sent for 112ms ~ 128ms when Key Pad is pressed.
9. IP terminals do not support Add-on Module feature.
10. IP Enabled D
term uses only one synthesized melody (Minuet), built into an IP adapter unit. Music on
Hold using external source is not available for the IP Enabled D term .
11. Internal Zone Page from the IP terminals has the following conditions:
ƒ IP Enabled D term can page up to 3 D term /IP Enabled D term terminals.
ƒ Legacy D term can page up to 16 D term /IP Enabled D term terminals.
ƒ IP stations cannot provide all zone paging (receive reorder tone).
Service Conditions on System Registration
1. The IP Enabled D term can be registered in the NEAX 2000 IPS in Login method (with password
protected) or Automatic Login method (MAC address authentication). The registration method can be
assigned in a station class of service.
Note: the D
term
SP20/SP30 (soft phone) is registered in Automatic Login method only.
2. The Login method allows the IP station user to be registered in the system by entering its own login
code (station number) and password. The station user can login to the system from any IP Enabled
D
term terminal in the system, which is assigned to Login method. The Automatic Login method (MAC
address authentication) allows the IP Enabled D term to be registered in the system at the installation
time by entering its own login code (station number) and a special password for installation
engineers.
Once the terminal is registered, the station user does not have to login and logout to use the IP
Enabled D term .
3. Up to 8-digit password can be assigned by system programming. 0 to 9, A and B can be used as a
password. The password can be masked by “*” on the LCD of IP Enabled D term .