NEC NEAX NDA-24349 - Manual (Page 205)

Chapter 9 Descriptions
NEAX 2000 IPS Request for Proposal (RFP) Reference Guide Page 9- 47
NDA-24349, Issue 4
Wireless Feature Descriptions
Analog PBX Interface
This feature allows the WCS to be integrated
with many types of PBXs and to activate
various PBX services by sending hookflash
signal and DTMF tone.
Announcement - PS No Answer /
Announcement - PS Out of Zone
This feature allows calls to a D term PS III which
cannot be paged in a predetermined period of
time to be routed to the announcement
notifying the calling party that the D
term PS III
cannot answer. Announcements can be
divided between Announcement-PS No
Answer and Announcement-PS Out of Zone
depending on the D
term PS III condition.
Automatic Release - Out of Zone Calls
When a D term PS III user engaged in a call
moves out of the service area or enters a
radio zone where all the channels are busy
and the communication becomes unavailable,
the call will be disconnected automatically,
and the other party receives reorder tone.
Call Forwarding-Not Available
When a D term PS III is powered off or out of
zone, a call directed to the D term PS III is
forwarded to a VMS, and a voice mail
message can be recorded to the VMS and
checked from the D
term PS III. Also the VMS
can page the D term PS III automatically after
the voice mail message is recorded.
Call Forwarding - PS Out of Zone
This feature allows calls directed to a D term PS
III, which is power off or out of zone to be
routed to an another station, an Attendant, an
outside number or voice mail equipment. The
call forwarding destination can be set/
cancelled from the D
term PS III station or
MAT/CAT.
CCIS Interface
This feature allows the WCS to be integrated
with NEC PBXs with CCIS interface.
Calling Name Display - PS
Without answering incoming calls or hold calls
terminates to the D
term PS III, the calling
party’s name can be confirmed by the
indications on the LCD.
Calling Number Display - PS
This feature provides a display on the LCD of
a D
term PS III receiving a call, indicating the
station number.
DTMF Signal Sender
This feature allows a D term PS III user to send
the DTMF signal (tone) to the called party
(terminal, voice mail system, etc.) while
engaged in communication.
GroupCall-Automatic Conference (6/10-
Party)
This feature permits a D term PS III user,
Multiline Terminal user or Single Line
Telephone user within the system to establish
a conference among as many as six or ten
parties. From a Dterm PS II/D term /Single
Line Telephone, a maximum of 9 PSs can be
paged simultaneously except the conference
leader. The PSs are assigned to the
simultaneous paging groups as participants
by the system data beforehand.