IBM SG24-4817-00 - Manual (Page 269)

This soft copy for use by IBM employees only.
lanEmulation OBJECT IDENTIFIER ::= { node 11 }
lanEmulationServer OBJECT IDENTIFIER ::= { lanEmulation 1 }
lesConfTable OBJECT-TYPE
SYNTAX SEQUENCE OF LesConfEntry
ACCESS not-accessible
STATUS mandatory
DESCRIPTION
″
This table contains the specific configuration
parameters of the embedded LAN emulation servers.
″
::= {lanEmulationServer 1}
lesConfEntry OBJECT-TYPE
SYNTAX LesConfEntry
ACCESS not-accessible
STATUS mandatory
DESCRIPTION
″
Entries of the lesConfTable. Each entry corresponds to
a Lan emulation server embedded in the atm control point.
″
INDEX { lesIndex }
::= { lesConfTable 1 }
LesConfEntry ::= SEQUENCE {
lesIndex
INTEGER,
lesMaxNumberOfClients
INTEGER,
lesLecLastChange
INTEGER }
lesIndex OBJECT-TYPE
SYNTAX INTEGER
ACCESS not-accessible
STATUS mandatory
DESCRIPTION
″
A value which uniquely identifies a
lan emulation server in the lesConfTable.
″
::= { lesConfEntry 1 }
lesMaxNumberOfClients OBJECT-TYPE
SYNTAX INTEGER
ACCESS read-write
STATUS mandatory
DESCRIPTION
″
The maximum number of clients supported by
this lan emulation server.
The maximum number of clients cannot be set
if the associated LES is started.
The total number of clients on all the embedded
lan emulation servers in one node must not exceed 128.
″
::= { lesConfEntry 2 }
lesLecTableLastChange OBJECT-TYPE
SYNTAX TimeTicks
ACCESS read-only
STATUS mandatory
DESCRIPTION
″
The value of the sysUpTime the last time a change was detected
Appendix E. IBM ATM Campus Switch Private MIBs
253