IBM SG24-4817-00 - Manual (Page 102)

This soft copy for use by IBM employees only.
Figure 33. Sample PVP Configuration
You display configuration information about PVPs using the SHOW PVC
command, as described in 5.1.5, “How to Configure PVCs” on page 83.
The following is an example of the output display for a PVP.
8285A> set pvc 2.7 100 1.9 2 path 14 15 best_effort
PVC set and started.
8285A> show pvc all
Local endpoint | Remote endpoint |
-----------------------------|-------------------|
Port id type Vpi/Vci | Port Vpi/Vci HNb| role |QOS| Status
-----------------------------|-------------------|---------|---|---------
2.07
100 PTP-PVP 14/* | 1.09 15/* 2| Primary | BE|Active
8285A>
5.1.8 How a VPI/VCI Is Allocated to SVCs
For virtual connections (both SVCs and PVCs), the VPI/VCI allocation is
performed on a per-port basis.
For an SVC, it
′
s always the 8285
′
s role to allocate any VPI/VCI used by the SVC
at each segment of the connection. The procedure for allocating a VPI/VCI for
the SVCs is based on the following considerations:
86
ATM Workgroup Solutions: Implementing the 8285 ATM Switch