IBM SG24-4817-00 - Manual (Page 234)

This soft copy for use by IBM employees only.
STATUS mandatory
DESCRIPTION
″
The VCI value for this connection.
″
::= { vcXConnectEntry 3 }
vcXOutIndex OBJECT-TYPE
SYNTAX INTEGER
ACCESS read-only
STATUS mandatory
DESCRIPTION
″
The interface number for this ATM port.
″
::= { vcXConnectEntry 4 }
vcXOutVpi OBJECT-TYPE
SYNTAX INTEGER
ACCESS read-only
STATUS mandatory
DESCRIPTION
″
The VPI value for this connection.
″
::= { vcXConnectEntry 5 }
vcXOutVci OBJECT-TYPE
SYNTAX INTEGER
ACCESS read-only
STATUS mandatory
DESCRIPTION
″
The VCI value for this connection.
″
::= { vcXConnectEntry 6 }
vcXType OBJECT-TYPE
SYNTAX INTEGER { unicast (1),
multicast (2)
}
ACCESS read-only
STATUS mandatory
DESCRIPTION
″
Whether this cross-connection is part of a unicast or a
multicast connection.
″
::= { vcXConnectEntry 7 }
vcXDirection OBJECT-TYPE
SYNTAX INTEGER { upstream (1),
downstream (2)
}
ACCESS read-only
STATUS mandatory
DESCRIPTION
″
Whether this entry identifies this cross-connection in
the upstream or downstream flow, as seen from the root.
Downstream means that the connection was set up from the
in parameters (interface, VPI, VCI) to the out parameters
(interface, VPI, VCI).
In particular, for a multicast SVC, this means that the
call initiator (the root in this case) is on the interface
side labeled vcXInIndex.
Upstream means that the connection was set up from the
218
ATM Workgroup Solutions: Implementing the 8285 ATM Switch