IBM SG24-4817-00 - Manual (Page 230)

This soft copy for use by IBM employees only.
port is disabled.
″
::= { interfaceEntry 16}
interfaceFrameFormat OBJECT-TYPE
SYNTAX INTEGER {
none (1),
sonet-sts-3c (2),
sdh-stm-1 (3),
ds3 (4),
e3 (5)
}
ACCESS read-write
STATUS mandatory
DESCRIPTION
″
The format of the frames exchanged on this port.
For a 155 Mbits LAN port, 2 formats are supported:
sonet-sts-3c and sdh-stm-1. It can only be
modified if the port atm access is UNI or NNI.
The frame format of a wan port cannot be modified.
For the other ports, the frame format cannot be
modified and is always returned as none.
The frame format can be changed only when the port
is disabled.
″
::= { interfaceEntry 17}
-- switch statistics
globalThroughputStats OBJECT IDENTIFIER ::= { physical 5 }
globalThroughputMonitoring OBJECT-TYPE
SYNTAX INTEGER {
on (1),
off (2)
}
ACCESS read-write
STATUS mandatory
DESCRIPTION
″
When on, the switch throughput is monitored.
When off, the switch thoughput is not monitored.
Note that the monitoring decreases the system
overall performances.
″
::= { globalThroughputStats 1 }
globalThroughputAggregateOutCells OBJECT-TYPE
SYNTAX Counter
ACCESS read-only
STATUS mandatory
DESCRIPTION
″
The total number of cells transmitted from the
switch.
Note that this value is the aggregate throughput
of all the ports on several minutes.
″
::= { globalThroughputStats 2 }
receiveTopList OBJECT-TYPE
SYNTAX DisplayString
ACCESS read-only
STATUS mandatory
DESCRIPTION
214
ATM Workgroup Solutions: Implementing the 8285 ATM Switch