IBM SG24-4817-00 - Manual (Page 126)

This soft copy for use by IBM employees only.
Table 26 (Page 2 of 2). References and Process Quick Guide
Task References
Monitoring and
Troubleshooting • Use the respective ATM Module Installation and User
′
s
Guides
−
Understanding LEDs
−
Troubleshooting
• IBM 8260/8285 ATM Command Reference Guide,
SA33-0385
− SHOW MODULE
−
SHOW MODULE VERBOSE
−
SHOW PORT
− SHOW PORT VERBOSE
−
SHOW STATIC_ROUTE
−
SHOW LOGICAL_LINK
6.4 Microcode/Picocode Considerations
The following section describes:
• Reasons for upgrading microcode
• How to acquire the latest microcode
• How to upgrade the microcode
6.4.1 Reasons for Upgrading Microcode
As part of your network operations plan, it is a good practice to include
maintaining your network devices with the most recent software/microcode
available. This allows you to take advantage of the newest features, to comply
with the latest standards, and to interoperate with the widest number of vendors.
The latest microcode levels for the 8285 ATM Control Point are:
• Release 1.3.0
−
Support for the A03-MB155 module.
−
Additional LANE support including support for external LECS via either
configured address or dynamic discovery.
• Release 1.4.0
Release 1.4.0 is a major upgrade. It includes new operating code as well as
new microcode for the base unit and all available 8285 modules. New and
enhanced features include:
−
Increases the number of connections available per module from 992 to
4064.
−
Allows for variable VPC/VCC value ranges enabling either more paths
with fewer channels each, or fewer paths with more channels each.
−
Supports ATM Forum Available Bit Rate (ABR) Service on the ATM
12-Port 25 Mbps UTP Concentrator Module, the ATM 3-Port 155 Mbps
LAN Concentration Module, and on the 12-port 25 Mbps base unit.
110
ATM Workgroup Solutions: Implementing the 8285 ATM Switch