GarrettCom Magnum MNS-6K - Manual (Page 83)

M A G N U M 6 K S W I T C H E S , M N S - 6 K U S E R G U I D E
Magnum6K25(auth)##
auth disable
802.1X Authenticator is disabled.
Magnum6K25(auth)##
authserver ip=192.168.1.239 secret=secret
This command is not necessary, however is shown for
completeness in case there was a RADIUS server
defined and a previously set authentication scheme
Successfully set RADIUS Authentication Server parameter(s)
Magnum6K25(auth)##
auth enable
802.1X Authenticator is enabled.
Magnum6K25(auth)##
show auth ports
Port
Status Control Initialize Current State
================================================================
1
Enabled Auto Deasserted Authorized
2 Enabled ForcedAuth Asserted Unauthorized
3 Enabled Auto Deasserted Authorized
4 Enabled Auto Deasserted Unauthorized
5 Enabled Auto Deasserted Unauthorized
6 Enabled Auto Deasserted Unauthorized
7 Enabled Auto Deasserted Unauthorized
8 Enabled Auto Deasserted Unauthorized
9 Enabled Auto Deasserted Unauthorized
10 Enabled Auto Deasserted Unauthorized
11 Enabled Auto Deasserted Unauthorized
12 Enabled Auto Deasserted Unauthorized
13 Enabled Auto Deasserted Unauthorized
14 Enabled Auto Deasserted Unauthorized
15 Enabled Auto Deasserted Unauthorized
16 Enabled Auto Deasserted Unauthorized
-- Port not available
Magnum6K25(auth)##
show auth config
802.1x Authenticator Configuration
========================================
Status
: Enabled
RADIUS Authentication Server
========================================
IP Address
: 192.168.1.239
UDP Port : 1812
Shared Secret : secret
Magnum6K25(auth)##
backend port=2 supptimeout=45 servertimeout=60 maxreq=5
Successfully set backend server authentication parameter(s)
Backend command is used for setting
characteristics of the timeouts and number
of requests before access is denied.
Command included for completeness –
validate the RADIUS server settings
Port #2 is where
RADIUS server
is connected
Enable the authentication
82