GarrettCom Magnum MNS-6K - Manual (Page 135)

M A G N U M 6 K S W I T C H E S , M N S - 6 K U S E R G U I D E
134
RSTP CONFIGURATION
-----------------
Rapid STP/STP Enabled(Global) : NO
Magnum6K25(stp)##
F
IGURE
78 – Configuring STP parameters
List of commands in this chapter
Syntax show stp - regardless of whether STP is enabled or disabled (default) this
command lists the switch’s full STP configuration, including general settings and port settings
Syntax stp – STP Configuration mode
Syntax stp - Start (Enable) or stop (Disable) STP
Syntax priority [port=] value=<0-255 | 0-65535> - specifies the port or
switch level priority. When a port(s) are specified the priority is associated with ports and their value is 0-
255. If no ports are specified, then the switch (bridge) priority is specified and its value is 0-65535
Syntax cost port= value=<0-65535> - cost is specific to a port and the port(s)
have to be specified
Syntax port port= status= - specific ports may not need to
participate in STP process. These ports typically would be end-stations. If you are not sure – let MNS-6K
software make the decisions
Syntax timers forward-delay=<4-30> hello=<1-10> age=<6-40> - change the STP Forward
Delay, Hello timer and Aging timer values