Exiting, List of commands in this chapter, Igure – GarrettCom Magnum MNS-6K User Manual
Page 34: Key completed the command, 18 – logout command
M A G N U M 6 K S W I T C H E S , M N S - 6 K U S E R G U I D E
OR
Magnum6K25>
se
password
timeout
vlan
Magnum6K25>
set
F
IGURE
17
-
Listing commands options – note the command was not completed and the TAB key
completed the command.
Exiting
To exit from the CLI interface and terminate the console session use the ‘logout’
command. The logout command will prompt you to ensure that the logout was not
mistakenly typed.
Syntax logout
Magnum6K25#
logout
Logging out from the current session...[ 'Y' or 'N']
Y
Connection to the host lost
F
IGURE
18 – logout command
List of commands in this chapter
Syntax ipconfig [ip=
[add|del] – to set IP address on the switch
Syntax save – save changes made to the configuration
Syntax reboot – restart the switch – same effect as physically turning off the power
Syntax show setup – show setup parameters
Syntax show config – show setup parameters configured
Syntax enable
Syntax add user=
Syntax delete user=
33