GarrettCom Magnum MNS-6K - Manual (Page 12)

List of Figures
F IGURE 1 - HyperTerminal screen showing the serial settings................................................................. 24
F
IGURE
2 - Prompt indicating the switch model number as well as mode of operation – note the
commands to switch between the levels is not shown here.............................................................. 25
F IGURE 3 -
Setting IP address on the switch.........................................................................................26
F
IGURE
4 - Rebooting the switch ..........................................................................................................27
F IGURE 5 -
Viewing the basic setup parameters. You can use ‘show setup’ or ‘show sysconfig’ to
view setup parameters ................................................................................................................ 27
F IGURE 6 - Switching users and privilege levels. Note the prompt changes with the new privilege
level. ......................................................................................................................................... 28
F
IGURE
7 - Adding a user with Manager level privilege .......................................................................29
F IGURE 8 -
Deleting a user .................................................................................................................29
F
IGURE
9 - Changing the password for a specific user...........................................................................29
F IGURE 10 -
Changing the privilege levels for a user .............................................................................30
F IGURE 11 – Creating user access privileges........................................................................................... 30
F
IGURE
12 - Help command..............................................................................................................31
F IGURE 13 -
Help for a specific command...........................................................................................31
F
IGURE
14 - Options for the ‘show’ command......................................................................................32
F IGURE 15 -
Listing commands available (at the operator level) ...........................................................32
F IGURE 16 - Listing commands starting with a specific character..........................................................32
F
IGURE
17 - Listing commands options – note the command was not completed and the TAB
key completed the command. ...................................................................................................... 33
F IGURE 18 – logout command .............................................................................................................. 33
F
IGURE
19 - Checking the IP settings..................................................................................................36
F IGURE 20 -
Changing the boot mode of the switch ..............................................................................38
F IGURE 21 - Changing telnet access – note in this case, the enable command was repeated without
any effect to the switch................................................................................................................ 38
F IGURE 22 -
Reviewing the console parameters – note telnet is enabled .................................................39
F IGURE 23 -
Example of a telnet session.............................................................................................39
F
IGURE
24 – managing and viewing multiple telnet sessions .................................................................. 40
xi