GarrettCom Magnum MNS-6K - Manual (Page 168)

M A G N U M 6 K S W I T C H E S , M N S - 6 K U S E R G U I D E
167
Syntax s-ring del port= - remove the switch from S-Ring topology by eliminating the
end ports on the switch
Syntax lll - enable or disable LLL on the switch
Syntax lll add port= - enable LLL on the list of specified ports
Syntax lll del port= - disable LLL on the list of specified ports
Syntax show lll – display the status of LLL
Syntax rstp – STP Configuration mode
Syntax rstp - Start (Enable) or stop (Disable) STP
Syntax set stp type= - set the spanning tree protocol to be IEEE 802.1d or 802.1w
(Rapid Spanning Tree Protocol)
Syntax show active-stp – Display which version of STP is currently active
Syntax show rs-ring – show the status of RS-Ring status and configuration
Syntax rs-ring - enable or disable RS-Ring capabilities
Syntax rs-ring add port= - define ports which make up the RS-Ring ports. Note as
discussed earlier, you can create multiple RS-Rings on a switch
Syntax rs-ring del port= - remove the switch from RS-Ring topology by eliminating the
end ports on the switch