GarrettCom Magnum MNS-6K - Manual (Page 295)

M A G N U M 6 K S W I T C H E S , M N S - 6 K U S E R G U I D E
Command Description
show-router displays detected IGMP-enabled router ports
show-stats port= displays 802.1x related statistics
show-timers show the values of the timers set for RSTP
show-trap [id=] shows the configured trap stations in tabular
format - id is optional and is the number
corresponding to the trap entry number in the
table
show-user [id=] display all or specific view entries - id is optional
and is the number corresponding to the view entry
number in the table
show-view [id=] display all or specific view entries - id is optional
and is the number corresponding to the view entry
number in the table
show-vlan list all the VLANs (including dynamic
VLANs) on the switch
signal port=
port to monitor and signal to send in case of
breach of port security
smtp configure the SNMP alerts to be sent via email
smtp enables or disables SMTP to send SNMP
alerts by email
snmp enter the SNMP Configuration mode
snmpv3 enter the SNMP V3 configuration mode – note
enable SNMP V3 by using the
“set snmp”
command which follows
sntp [enable|disable] enable or disable the SNTP services
s-ring enable or disable S-ring capabilities
s-ring add port= define ports which make up the s-ring ports.
Note as discussed earlier, you can create multiple
s-rings on a switch
s-ring del port= remove the switch from S-ring topology by
eliminating the end ports on the switch
s-ring learn start the learning process to discover the ring and
the ports which make up the s-ring
294