GarrettCom Magnum MNS-6K - Manual (Page 259)

M A G N U M 6 K S W I T C H E S , M N S - 6 K U S E R G U I D E
Syntax command - options for a command
Syntax - listing all commands available at the privilege level
Syntax - options for a command
Syntax - listing commands starting with the character
Syntax logout – logout from the CLI session
Chapter 3 – IP Address and
System Information
Syntax set bootmode type= [bootimg=]
[bootcfg=[] – assign the boot mode for the switch
Where
- where
dhcp – look only for DHCP servers on the network for the IP address. Disable
bootp or other modes
bootp – look only for bootp servers on the network. Disable dhcp or other mode
manual – do not set the IP address automatically
auto - the switch will first look for a DHCP server. If a DHCP server is not found,
it will then look for a BootP server. If that server is not found, the switch will
check to see if the switch had a pre-configured IP address. If it did, the switch
would be assigned that IP address. If the switch did not have a pre-configured
IP address, it would inspect if the IP address 192.168.1.2 with a netmask of
255.255.255.0 is free. If the IP address is free, MNS-6K will assign the switch
that IP address. If the address is not free, MNS-6K will poll the network for
DHCP server then BootP server then check if the IP address 192.68.1.2 is freed
up
bootimg= - valid with type=bootp only. This option allows the
switch to load the image file from the BootP server. This is useful when a new switch
is put on a network and the IT policies are set to load only a specific MNS-6Kimage
which is supported and tested by IT personnel.
bootcfg= - valid with type=bootp only. This option allows the switch
to load the configuration file from the BootP server. This is useful when a new switch
is put on a network and the specific configurations are loaded from a centralized
BootP server
Syntax telnet - enables or disables telnet sessions
Syntax telnet [port=] – telnet from the switch
258