GarrettCom Magnum MNS-6K - Manual (Page 273)

M A G N U M 6 K S W I T C H E S , M N S - 6 K U S E R G U I D E
Syntax set-qi interval= - The IGMP querier router periodically sends general host-query messages.
These messages are sent to ask for group membership information. This is sent to the all-system multicast
group address, 224.0.0.1. The default value is 125 seconds. The valid range can be from 60 to 127
seconds.
Syntax set-qri interval= - The query response interval is the maximum amount of time that can
elapse between when the querier router sends a host-query message and when it receives a response from a
host. The Default value is 10 seconds. The Range can be from 2 to 270 seconds. Restrictions apply to the
maximum value because of an internal calculation that is dependent on the value of the Query Interval
Syntax mode= - Toggle the IGMP mode from L2 to nnormal or IGMP-L2
Chapter 17 - GVRP
Syntax
show gvrp - shows whether GVRP is disabled, along with the current settings for the maximum
number of VLANs and the current Primary VLAN
Syntax
gvrp > - enable or disable GVRP
Syntax
show-vlan – list all the VLANs (including dynamic VLANs) on the switch
Syntax set-ports port= state= - set the state of the port
to learn, block or disable for GVRP. Note the default state is disable
Syntax static vlan= - convert a dynamic VLAN to a static VLAN
Syntax set-forbid vlan= forbid= - sets the forbid GVRP
capability on the ports specified
Syntax show-forbid – display the ports with GVRP forbid capabilities
Chapter 18 – SNMP
Syntax snmp – enter the SNMP Configuration mode
Syntax snmpv3 – enter the SNMP V3 configuration mode – note enable SNMP V3 by using the
“set
snmp” command which follows
Syntax set snmp type= - define the version of SNMP to use – the option all supports all versions
(v1, v2 and v3) – v1 restricts SNMP to v1 only. By default – SNMP v1only is enabled
Syntax show active-snmp – shows the version of SNMP currently in use
272