Tag vlans and management, Igure, 72 – example for tag vlan – GarrettCom Magnum MNS-6K User Manual
Page 119
M A G N U M 6 K S W I T C H E S , M N S - 6 K U S E R G U I D E
----------------------------------------------------
PORT |
MODE
| STATUS
----------------------------------------------------
14
|
TAGGED
| DOWN
15
|
TAGGED
| DOWN
16
|
TAGGED
| DOWN
VLAN ID: 30
Name : marketing
Status : Active
----------------------------------------------------
PORT |
MODE
| STATUS
----------------------------------------------------
14
|
TAGGED
| DOWN
15
|
TAGGED
| DOWN
16
|
TAGGED
| DOWN
F
IGURE
72 – Example for Tag VLAN
Tag VLANs and Management
Normally, for security reasons, a user may want to disable management information propagating
on a specific VLAN. By default, management information propagates on VLAN 1 (default
VLAN). To disable management or to enable management information from propagating on a
VLAN, please use the commands listed below:
Syntax add id=
[forbid=
GarrettCom recommends to disable management function when the VLANs are added
using the add command shown above. By default, management is allowed (enabled) on a
VLAN.
Syntax edit id=
[
THE EDIT COMMAND ONLY ASSOCIATES THE PORT WITH
THE VLANS. So for example, if VLAN 5 had port 10-14, an edit
command on port 14 only will drop ports 10-13 from VLAN 5. See
example below.
Magnum 6K25#
vlan type=tag
Before exiting – don’t forget to save the configuration or
discard the configuration by doing a reboot.
118