Configuring rs-ring, Igure, Activating rs-ring on the switch – GarrettCom Magnum MNS-6K User Manual
Page 165

M A G N U M 6 K S W I T C H E S , M N S - 6 K U S E R G U I D E 
 
 
Rings are simple structures. Either one port of a pair is forwarding or both are. Not 
complicated; not much to go wrong. 
Configuring RS-Ring
RS-Ring is a licensed software feature from GarrettCom Inc. Before using the RS-Ring 
capabilities; authorize the use of the software with the S-Ring license key. The same license 
key is used for either the S-Ring or RS-Ring. To obtain the license key, please contact 
GarrettCom Inc. Sales (for purchasing the S-Ring feature) or Technical Support (to obtain 
the 12 character key.) If the S-Ring capability was purchased along with the switch, the 
software license code will be included with the switch. 
 
Syntax authorize 
Don’t forget to use the “save” command to save the key 
 
 
Magnum6K25#
authorize s-ring key=abc123456789
S-RING Module Successfully Authorized 
Please Save Configuration. 
Magnum6K25# 
save
 
 Saving current configuration 
 Configuration saved 
 
 Saving current event logs 
 Event logs saved 
F
IGURE
91
– Activating RS-Ring on the switch
Since RS-Ring uses RSTP, RSTP has to be activated and enabled. Please refer to the Chapter 
on 
Rapid Spanning Tree Protocol (RSTP)
for more information. Some of the commands are
repeated here for clarity. Using RS-Ring with multiple switches, it is recommended to do the 
following: 
1) On all switches in the ring topology, authorize the use of RS-Ring software 
2) On all the switches in the ring, enable RSTP 
3) On all the switches in the ring designate the ports which make the ring pair 
4) Only the ports on the RS-Ring must be enabled with RS-Ring capability 
5) DO NOT enable S-Ring and RS-Ring in a given ring at the same time. 
6) Enable RS-Ring on each switch 
 
Ports associated with RS-Ring should have the following settings 
•
Same Speed - 100Mbps connection provides faster recovery than 10 Mbps 
networks 
•
Same Duplex capabilities -
 
The necessary commands are 
 
Syntax rstp – STP Configuration mode 
164
