FUJITSU PRIMERGY MX130 S2 User Manual
Primergy mx130 s2 server
Table of contents
Document Outline
- Contents
- Version history
- 1 Introduction
- 2 Before you start
- 3 Important information
- 4 Basic hardware procedures
- 5 Basic software procedures
- 5.1 Starting the maintenance task
- 5.2 Completing the maintenance task
- 5.2.1 Updating the system board BIOS
- 5.2.2 Updating RAID controller firmware
- 5.2.3 Enabling Option ROM scan
- 5.2.4 Verifying and configuring the backup software solution
- 5.2.5 Viewing the System Event Log (SEL)
- 5.2.6 Enabling BitLocker functionality
- 5.2.7 Performing a RAID array rebuild
- 5.2.8 Looking up changed MAC addresses
- 5.2.9 Using the Chassis ID Prom Tool
- 6 Power supply
- 7 HDDs and accessible drives
- 7.1 Basic procedure
- 7.2 Mounting order
- 7.3 Installing 3.5-inch HDD in HDD1 / HDD2 chassis bay
- 7.4 Removing 3.5-inch HDD out of HDD1 / HDD2 chassis bay
- 7.5 Installing additional 3.5-inch HDD in 3.5- inch chassis bay
- 7.6 Removing additional 3.5-inch HDD out of 3.5-inch chassis bay
- 7.7 Installing additional 3.5-inch HDD in 5.25- inch dummy cover
- 7.8 Removing 3.5-inch HDD out of 5.25-inch dummy cover
- 7.9 Installing additional 3.5-inch HDD in 5.25- inch ODD/HDD bracket
- 7.10 Removing 3.5-inch HDD out of 5.25-inch ODD/HDD bracket
- 7.11 Installing 5.25-inch dummy cover
- 7.12 Removing 5.25-inch dummy cover
- 7.13 Installing ODD in 5.25-inch chassis bay
- 7.14 Removing ODD out of 5.25-inch chassis bay
- 7.15 Installing slimline ODD in 5.25-inch ODD/HDD bracket
- 7.16 Removing slimline ODD out of 5.25-inch ODD/HDD bracket
- 7.17 Installing backup drive in 5.25-inch chassis bay
- 7.18 Removing backup drive out of 5.25-inch chassis bay
- 7.19 Installing slimline ODD in slimline chassis bay
- 7.20 Replacing slimline ODD out of slimline chassis bay
- 8 System fan
- 9 Expansion cards
- 10 Main memory
- 11 Processors
- 12 System board and components
- 13 Front panel and front USB
- 14 Cables
- 15 Appendix