FUJITSU PRIMERGY MX130 S2 - Manual (Page 103)

MX130 S2 Upgrade and Maintenance Manual 103
HDDs and accessible drives
V
CAUTION!
Always replace dummy modules into unused drive bays to comply with
applicable EMC regulations and satisfy cooling requirements.
7.8.4 Concluding steps
Perform the following procedures to complete the task:
Ê
Install the 5.25-inch dummy cover as described in section "Installing 5.25-
inch dummy cover" on page 110 .
Ê
Follow all procedures described in section "Closing the server" on page 54 .
7.9 Installing additional 3.5-inch HDD in 5.25-
inch ODD/HDD bracket
7.9.1 Required tools
●
Preliminary and concluding steps: tool-less
●
Installing a 3.5-inch HDD
– Phillips PH2 / (+) No. 2 screw driver
7.9.2 Preliminary steps
Before installing a 3.5-inch HDD, perform the following steps:
Ê
Follow all procedures described in section "Opening the server" on page 48 .
Ê
Locate the correct drive bay as described in section "Mounting order" on
page 82 .
Ê
Remove the 5.25-inch dummy cover as described in section "Removing a
5.25-inch dummy cover" on page 113 .