FUJITSU PRIMERGY MX130 S2 - Manual (Page 197)

MX130 S2 Upgrade and Maintenance Manual 197
Processors
Figure 124: Applying thermal paste
Ê
Apply a small streak of thermal paste (1.0 gram, see description above) to
the center of the processor surface as shown.
V
CAUTION!
Do not mix different types of thermal paste.
11.3.7 Installing the processor heat sink
Refer to section "Installing the processor heat sink" on page 190 for installing
the processor heat sink.
11.3.8 Concluding steps
Perform the following procedures to complete the task:
Ê
Follow all procedures described in section "Closing the server" on page 54 .
Ê
If available, update the system board BIOS to the latest version as described
in section
"Updating the system board BIOS" on page 62 .
Ê
If BitLocker functionality is used and has been disabled before starting the
maintenance task, re-enable BitLocker as described in section
"Enabling
BitLocker functionality" on page 66 .