FUJITSU PRIMERGY MX130 S2 - Manual (Page 58)

58 Upgrade and Maintenance Manual MX130 S2
Basic hardware procedures
4.6 Switching on the server
V
CAUTION!
●
Before switching on the server, make sure the server cover is closed.
In order to comply with applicable EMC regulations (regulations on
electromagnetic compatibility) and satisfy cooling requirements, the
PRIMERGY MX130 S2 server must not run while the server cover is
removed.
●
Follow the safety instructions in chapter "Important information" on
page 31 .
Ê
Connect all peripheral cables to the rear connector panel of the server.
Ê
Connect the power cord as described in section "Connecting the server to
the mains" on page 55 .
Ê
Connect the power cord to the power outlet.
Figure 13: Power button on the front panel
Ê
Press the On / Off button to start up the server (1).
Ê
Ensure that the power-on indicator in the On / Off button is lit green.
I
For more information see "Front panel and front USB" on page 223 .
/