FUJITSU PRIMERGY MX130 S2 - Manual (Page 254)

254 Upgrade and Maintenance Manual MX130 S2
Appendix
Buttons
15.4 Minimum startup configuration
If the server does not start up or other problems occur, it may be necessary to
take the system down to its most basic configuration in order to isolate the
defective component.
The minimum startup configuration consists of the following components and
cables:
Pos. Button Function
2 On / Off button
This button is used to switch the server on or off.
I
If the system is running an ACPI-compliant
operating system, the pressing the On / Off
button will performs a graceful shutdown.
Pressing and holding the On / Off button for
five seconds will switches the server off without
shutting down the operating system.
Field Replaceable Units (FRU)
Component Notes
System board no TPM or expansion cards installed
CPU with CPU heat sink
1 memory module
installed in slot 1
PSU
Table 7: Minimum startup configuration - components
Cable Notes and reference
Front panel cable
Power cable
see section "Replacing the power cable" on
page 239
Table 8: Minimum startup configuration - cables