B.1 pds–4k ascii remote control, Pds–4k ascii remote control – Barco PDS-4K HDMI Presentation Switcher User Manual
Page 198
R5912621 /01 PDS–4K
198
B.1 PDS–4K ASCII remote control
General
The user can remotely control the PDS– 4K presentation switcher via a telnet connection to the unit’s IP
address.
How to access the PDS–4K remotely
To access the PDS–4K remote commands, use the following procedure:
1.
In a command prompt window, type a telnet command in the following format:
> telnet nnn.nnn.nnn.nnn 9878
where the n’s represent the unit IP address and 9878 is the port.
2.
Press
Enter
The command prompt appears.
3.
At the command prompt, type a specific PDS–4K remote control command and press
Enter
.
ASCII remote commands
This section lists the PDS–4K remote commands, sorted by name.
ATRN
•
Description: Performs an Auto Transition on the currently active destinations. The currently selected Effect
type, rate and edge width will be used to transition preview to program.
•
Command Format: ATRN
•
Parameters:
Used to specify a transition time (duration of the transition) in seconds. Value ranges from 0 to 12. A 0
specify a cut transition. Any non-zero value (within range) will override the transition time in the controller. If
this argument is not specified, the current transition time known by the controller will be used.
•
Examples:
> ATRN 6
(Transition Preview to Program on currently active destinations in six seconds)
> ATRN 0
(Transition Preview to Program immediately. This is a CUT.)
> ATRN
(Transition Preview to Program using the transition time set in the controller)
•
Query Format: N/A
•
Query Response: N/A
PRESET
•
Description: Preset Settings. For parameter details, see below.
•
Command Format: PRESET
•
Parameters:
-s (save preset, 1-1000)
-r (recall preset, 1-1000)
-a (recall preset and auto transition, 1-1000)
•
Examples:
> PRESET -s 1
(Save currently selected destinations to preset 1)
> PRESET -r 10
(Recall preset 10)
PRESET -a 10
(Recall preset 10 and auto transition)
•
Query Format: N/A