HP BA322 90087 User Manual
Page 140
NOTE:
Do not attempt to explicitly remove SSL from your system. The PRODUCT REMOVE
command is not supported for SSL although there appears to be an option to remove SSL. SSL
is installed with the operating system and is tightly bound with it. Attempts to remove it might
not work as expected and can create undesirable side effects. An attempt to remove it results in
a message similar to the following:
%PCSI-E-HRDREF, product HP I64VMS SSL V1.4 is referenced by HP I64VMS OPENVMS V8.4
The two products listed above are tightly bound by a software dependency.
If you override the recommendation to terminate the operation, the
referenced product will be removed, but the referencing product will have
an unsatisfied software dependency and may no longer function correctly.
Please review the referencing product’s documentation on requirements.
Answer YES to the following question to terminate the PRODUCT command.
However, if you are sure you want to remove the referenced product then
answer NO to continue the operation.
Terminating is strongly recommended. Do you want to terminate? [YES]
7.9.5 Configure WBEM Services for OpenVMS (Optional; Integrity servers only)
WBEM Services for OpenVMS is installed automatically with OpenVMS installation. As with
other similar products, an OpenVMS upgrade does not automatically include WBEM Services
for OpenVMS if it is not already installed on the target system disk. In this case, you must install
the product separately using the PCSI PRODUCT INSTALL command. If you do not plan to use
WBEM Services for OpenVMS or any products that depend on it, simply do not configure the
software; if you have already configured the software, you can choose not to start it.
You must configure WBEM Services for OpenVMS to obtain the services provided by HP SIM
(Version 5.2 or later) and products such as Instant Capacity and gWLM. To provide services over
the network, both TCP/IP Services for OpenVMS and SSL (for security purposes) are required
and must be configured and running. (For information about configuring TCP/IP Services for
OpenVMS, see
.
To configure WBEM Services for OpenVMS on a system on which WBEM Services for OpenVMS
has never been installed and configured, follow the steps described in “
.” If you
are configuring the product on a system on which it has been configured previously, see
.
For more information about HP WBEM products, see the following website:
140
After Installing or Upgrading the OpenVMS Operating System