KEPCO KLN Series (750W, 1500W, 3000W), Main Contro Firmware Version 1.70 and higher - Manual (Page 87)

KLN Series 051614
3-41/(3-42 Blank)
3.7.4 UNDERSTANDING THE COMMAND STRUCTURE
Understanding the command structure requires an understanding of the subsystem command
tree illustrated in Figure 3-17. The “root” is located at the top left corner of the diagram. The
parser goes to the root if:
• a message terminator is recognized by the parser
• a root specifier is recognized by the parser
Starting at the root, there are various branches or paths corresponding to the subsystems. The
root keywords for the KLN Power Supply are :CALibrate, :DISPlay, :FETCh, :OUTPut, :SOURce
and :SYSTem.
FIGURE 3-17. TREE DIAGRAM OF SCPI COMMANDS USED WITH KLN POWER SUPPLY
CALibrate subsystem
CAL
DISPlay subsystem
DISP
:CONT
:CONT?
FETCh subsystem
FETC
:FETC?]
OUTPut subsystem
OUTP
[:STAT]
[:STAT]?
:OUTP
:OUTP?
:OUTP:PON
:OUTP:PON?
ROOT : (colon)
SYSTem subsystem
SYSTem
:BEEP
:BEEP?
:COMM
:LAN
:DHCP
:DHCP?
:GATE
:GATE?
:IP
:IP?
:IPAD
:IPAD?
:MAC
:MAC?
:RES
:SMAS
:SMAS?
:TEL:PORT
:TEL:PORT?
:ERR?
:KLOC
:KLOC?
:LOC
:REM
:VERS?
SOURce: subsystem
SOUR
:CURR
:CURR?
:PROT:LEV
: PROT:LEV?
:LIST
:RTIM
:RTIM?
:MEM
:CLS
:CURR:X
:CURR:X?
:LIST:X?
:REC:X
:REC:X?
:VOLT:X
:VOLT:X?
:VOLT
:VOLT?
:LIM
:LOW
:LOW?
:PROT:LEV
: PROT:LEV?