KEPCO KLN Series (750W, 1500W, 3000W), Main Contro Firmware Version 1.70 and higher - Manual (Page 63)

KLN Series 051614
3-17
3.3.22 SET/VIEW 2ND PART OF IP ADDRESS (LAN INTERFACE ONLY)
Used to set (if DHCP function is OFF) or view (if DHCP is ON) part 2 (nnn) of the 4-part IP
address (xxx.nnn.xxx.xxx) where nnn can be set from 0 to 254. Refer to PAR. 3.3.19 to set
DHCP on/off. When setting the IP address, verify that all four parts of the address are set cor-
rectly (see PARs. 3.3.21, 3.3.23 and 3.3.24).
1. Enter the menu (see PAR. 3.2.2 and Table 3-3) and rotate the encoder until Voltage display
shows (S.IP2) if DHCP is OFF or (V.IP2) if DHCP is ON to
access part 2 of IP address.
2. Press ENTER key to view setting.
For example (168) displayed in Current display for IP Address xxx.168.xxx.xxx.
3. If Voltage display shows (S.IP2), set by rotating encoder until Current display
shows desired setting (tap encoder to adjust 10’s or 100’s digit more rapidly). Press ENTER
to confirm.
3.3.23 SET/VIEW 3RD PART OF IP ADDRESS (LAN INTERFACE ONLY)
Used to set (if DHCP function is OFF) or view (if DHCP is ON) part 3 (nnn) of the 4-part IP
address (xxx.xxx.nnn.xxx) where nnn can be set from 0 to 254. Refer to PAR. 3.3.19 to set
DHCP on/off. When setting the IP address, verify that all four parts of the address are set cor-
rectly (see PARs. 3.3.21, 3.3.22 and 3.3.24).
1. Enter the menu (see PAR. 3.2.2 and Table 3-3) and rotate the encoder until Voltage display
shows (S.IP3) if DHCP is OFF or (V.IP3) if DHCP is ON to
access part 3 of IP address.
2. Press ENTER key to view setting.
For example (0) displayed in Current display for IP Address xxx.xxx.0.xxx.
3. If Voltage display shows (S.IP3), set by rotating encoder until Current display
shows desired setting (tap encoder to adjust 10’s or 100’s digit more rapidly). Press ENTER
to confirm.