KEPCO CA 26 - Manual

©2005, KEPCO, INC 1
Data subject to change without notice 228-1070 REV 1
I N S T R U C T I O N M A N U A L
CA 26
KEPCO
KEPCO, INC. " 131-38 SANFORD AVENUE " FLUSHING, NY. 11352 U.S.A. " TEL (718) 461-7000 " FAX (718) 767-1102
http://www.kepcopower.com " email: [email protected]
An ISO 9001 Company.
COVER
ENCLOSURES AND
HARDWARE SYSTEMS
I — DESCRIPTION
The Kepco Model CA 26 cover is supplied for use with the Kepco FAW 50 Watt Series of switching power supplies. The easily installed one-
piece steel cover is a separate option designed for shielding and protection. The cover is attached with one screw from the FAW 50W PCB
mounting.
II — INSTALLATION
1. Remove PCB mounting screw (A, Figure 1) along with lockwasher and flat washer, and set aside.
2. Attach cover: Engage the cut-out (B) on the cover with tab (B) on the FAW 50W chassis, apply a slight downward pressure at this interlock
point and push the cover forward. When the CA 26 cover is properly installed, the PC board will rest on top of flanges marked (C). The
mounting hole (A) in the cover will then line up with the mounting hole (A) in the FAW PC Card.
3. Fasten cover with screw (A).
FIGURE 1. COVER INSTALLATION