KEPCO KLN Series (750W, 1500W, 3000W), Main Contro Firmware Version 1.70 and higher - Manual (Page 32)

2-6 KLN Series 051614
2.4 INSTALLATION
2.4.1 RACK MOUNTING 750W MODELS
One or two (side by side) KLN 750W units can be mounted in a standard 19-inch rack (see Fig-
ure 1-2 for outline dimensions). The units are 1U high and do not require any gaps between
equipment above and below. Airflow is front to back only. Use the optional RA 81-1 Mounting Kit
(see Table 1-5) to mount a single unit. Use optional Mounting Kit RA 81-2 (see Table 1-5) to
mount two half-rack units side by side in a 19-inch rack.
2.4.1.1 MOUNTING ONE 750W 1/2-RACK UNIT IN 19-INCH RACK
1. On one side of the unit, mount one L-type bracket with knob (supplied with unit) to the unit
using two screws supplied with unit.
2. Mount the U-type bracket supplied in the Kit to the other side of the unit using two screws
supplied in Kit.
3. Mount the other L-type bracket with knob (supplied with unit) to the end of the U-type bracket
using two screws supplied with unit. The knobs can now be used to support the assembled
unit while installing in a 19-inch rack.
FIGURE 2-7. MOUNTING ONE KLN 750W UNIT IN 19-INCH RACK
2.4.1.2 MOUNTING TWO 750W 1/2-RACK UNITS IN 19-INCH RACK
To mount two KLN 750W units side-by-side in a 19 inch rack, use the RA 81-2 mounting kit (not
supplied, see Accessories, Table 1-5).
1. Place the two units side by side as they would be installed in the rack. On the outer side of
each unit (not facing the other unit), mount one L-type bracket with knob (supplied with unit)
to each unit using two screws supplied with unit for each (see Figure 1-2).