KEPCO KLN Series (750W, 1500W, 3000W), Main Contro Firmware Version 1.70 and higher - Manual (Page 62)

3-16
KLN Series 051614
3.3.20 DNS FUNCTION ON/OFF CONTROL (LAN INTERFACE ONLY)
Used to determine how the DNS address is assigned. Set this function to ON when connecting
to the network via a DHCP server to allow the server to assign the DNS server address. Set this
function to OFF when connecting the KLN directly to a computer. Figure 3-5 shows the com-
mands used to set/view addresses depending on whether DHCP and DNS functions are on or
off.
1. Enter the menu (see PAR. 3.2.2 and Table 3-3) and rotate the encoder until Voltage display
shows (DNS) to access DNS on/off setting.
2. Press ENTER key to view setting.
DNS ON displayed as (ON) in Current display.
DNS OFF displayed as (OFF) in Current display.
3. Rotate encoder until Current display shows desired setting, then press ENTER to confirm.
3.3.21 SET/VIEW 1ST PART OF IP ADDRESS (LAN INTERFACE ONLY)
Used to set (if DHCP function is OFF) or view (if DHCP is ON) part 1 (nnn) of the 4-part IP
address (nnn.xxx.xxx.xxx) where nnn can be set from 0 to 223. Refer to PAR. 3.3.19 to set
DHCP on/off. When setting the IP address, verify that all four parts of the address are set cor-
rectly (see PARs. 3.3.22 through 3.3.24). Figure 3-5 shows the commands used to set/view
addresses depending on whether DHCP and DNS functions are on or off.
1. Enter the menu (see PAR. 3.2.2 and Table 3-3) and rotate the encoder until Voltage display
shows (S.IP1) if DHCP is OFF or (V.IP1) if DHCP is ON to access
part 1 of IP address.
2. Press ENTER key to view setting.
For example, (192) displayed in Current display for IP Address 192.xxx.xxx.xxx
3. If Voltage display shows (S.IP1), set by rotating encoder until Current display
shows desired setting (tap encoder to adjust 10’s or 100’s digit more rapidly). Press ENTER
to confirm.