KEPCO KLN Series (750W, 1500W, 3000W), Main Contro Firmware Version 1.70 and higher - Manual (Page 58)

3-12
KLN Series 051614
3.3.12 MEMORY FLAG
There are 16 memory locations that can be used to store and recall power supply settings.
MEM.F is used to limit the range of locations that can be accessed. For example, when the
MEMORY FLAG is set as 05, it means that RECALL can only be executed from memory loca-
tions 01 through 05.
1. Enter the menu (see PAR. 3.2.2 and Table 3-3) and rotate the encoder until Voltage display
shows (MEM.F) to access MEMORY FLAG setting.
2. Press ENTER key to view setting.
Memory flag displayed as (01) in Current display.
3. Rotate encoder until Current display shows desired setting, then press ENTER to confirm.
3.3.13 BEEP
The BEEP function enables or disables the audible beep each time a front panel key is pressed.
1. Enter the menu (see PAR. 3.2.2 and Table 3-3) and rotate the encoder until Voltage display
shows (BEEP) to access BEEP function.
2. Press ENTER key to view setting.
Beep ON (default) displayed as (ON) in Current display.
Beep OFF displayed as (OFF) in Current display.
3. Rotate encoder until Current display shows desired setting, then press ENTER to confirm.
3.3.14 DISPLAY BRIGHTNESS
The brightness level for the Voltage and Current displays can be set from 0 (dimmest) to 5
(brightest).
1. Enter the menu (see PAR. 3.2.2 and Table 3-3) and rotate the encoder until Voltage display
shows (BRIT) to access BRIGHTNESS setting.
2. Press ENTER key to view setting
Brightness level (0, 1, 2, 3, 4 or 5) displayed in Current display, e.g., (3).
3. Rotate encoder until Current display shows desired setting, then press ENTER to confirm.